Publicité
Les langues disponibles
Les langues disponibles
POWER SOURCE (REMOTE CONTROL)
Battery installation:
1. Press the tab on the battery door and lift it off.
2.
Install two (2) "AAA" size batteries into the battery
compartment as the illustrated on right and the
polarity markings inside battery compartment.
3. Replace the battery door.
Battery precaution:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery compartment.
A reversed battery may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with
fresh ones.
4. If the batteries in the device are consumed or the device is not be used for a long period of time,
remove the batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; it can overheat and reputure.
(Follow battery manufacture's instructions.)
6. Do not dispose of battery in fires. Battery may explodes or leak.
7. Clean the battery contacts, and also those the device, prior to battery installation.
Remote Control Sensor
Remarks:
1. When there is an obstacle between the unit and
the transmitter, the transmitter may not operation.
2. When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light
shines on the remote control of the unit, the
remote operation may be unstable.
15 feet (5M)
11
POWER
Publicité
