Urmet 1083/58A Manuel D'installation page 11

1.2. WALL MOUNTING WITH
THE KIT REF. 1083/88
1. Fix the base of the container (supplied in the kit)
to the flush-mounting box mod. 503 or Ø 60mm
(2.36") as shown in the following figures:
n. 2 M3.5 x 19 mm
or, alternatively, with screws and anchors supplied
in the kit.
Ensure cables are led through the left
side.
2. Remove the 2 covers from the device.
DS1083-105A
Box Mod.503 -
horizontal
supplied
Box Mod.503 -
vertical
n. 2 M3.5 x 19 mm
supplied
Box
Ø 60 mm / 2.36''
n. 2 2.9 x 13 mm with
countersunk head
3. Secure the device to the base in the
recommended position.
4. Carry out the device connection to the system.
The end of a stranded conductor must
not be consolidated with mild soldering
in the points in which the conductor is
subject to contact pressure.
5. Carry out the device configuration by means of
jumpers and/or dip-switches.
6. Replace the terminal strip cover on the device
(the second transparent cover should not be
used because it prevents cover closing.)
7. Power on the device.
2
1
3
11