Velleman CAMTVI16N Mode D'emploi page 4

5. Installation
1. Remove the camera base.
2. Choose your mounting spot. Take the base as a template and drill the
necessary mounting holes. If necessary, drill a hole for routing the
cables. Insert a nylon plug in each hole.
3. Pass the camera cable through the base and fix the bracket using the
included screws. If applicable, pass the cable through the routing hole.
4. Slightly adjust the camera lens and aim it toward the surveillance
area.
5. Re-assemble the camera.
6. Connect and power your camera (see below). Check the viewing angle
on your PC.
7. Adjust the position and viewing angle if necessary.
6. Connection
1. Connect the power terminal of the camera to a 12 VDC regulated
power supply.
2. Connect the video output of the camera to the video input of your DVR
using a 75 Ω coaxial cable.
Remarks:

Only use a regulated 12 VDC power adapter. Using any other type will
damage this camera.

Protect the connectors against moisture by applying some insulating
tape over the connectors.
7. Camera Configuration
This camera has its own configuration menu. Either of the two methods
below allows access the menu.
7.1 Method 1
On the DVR live view, click the camera's channel to display it in full
1.
screen.
2. Open the control panel by clicking the camera and the panel icons.

V. 02 – 08/05/2018
move
change settings
enter menu or confirm
CAMTVI16N
4 ©Velleman nv