Bresser ClimaTemp IO Manuel D'instructions page 19

4.
5.
*further wireless sensors are optionally available
9 Manual time setting
1.
2.
3.
4.
5.
6.
10 Alarm setting
1.
2.
3.
4.
5.
19 / 22
NOTICE! Each connected wireless sensor must be set to
a different channel. If only one wireless sensor is
connected, it should be set to CH1.
Press the CHANNEL button on the base station several
times to display the measured values for the individual
channels constantly or in four-second alternating se-
quences. The selected channel is shown in the display.
Press CHANNEL button for about 3 seconds to reset the
values and search for a wireless sensor (RF signal).
Press the SET button for approx. 4 seconds to enter the
time setting mode.
Digits to be set are flashing.
Press UP or DOWN button to change the value.
Press the SET button to confirm and switch to the next
setting.
Sequence of the settings: Year > Month > Day > Lan-
guage > 12-/24-hour mode > Hours > Minutes
Finally, press the SET button to save the settings and
exit settings mode.
Press and hold ALARM button for approx. 2 seconds to
enter the alarm time setting mode.
Digits to be set are flashing.
Press UP or DOWN button to change the value.
Press ALARM button to confirm and continue to the
next setting.
Settings order: Hours > Minutes