Publicité
Les langues disponibles
Les langues disponibles
Illustration F and G:
6. Place the inner tent 7 in the outer tent 1 .
Attach the fastening hooks of inner tent to
the metal loops on the front side and plastic
loops on the back of the outer tent.
Illustration G:
7.
Attach the fastening hooks of outer ground
sheet 6 to the metal loops on the front side
and plastic loops on the door of the outer
tent 1 .
Illustration H:
8. Open the ventilating windows 8 and secure
them with the spacers 9 .
9.
Secure the tent 1 until taut and pull all
of by tensioning guy ropes 4 and floor
fastenings with the tent pegs 5 .
10. Stretch the tent until taut and pull all of the
corners and guy ropes 4 until they are tight.
11. Do not over-tighten the guy ropes 4 , if the
strength of the wind increases the attachment
point and seam of the tent might tear.
Illustration I:
12. Open the entrance, unroll it and attach it
with the two fasteners.
˜ Taking down the tent
Clean the tent both inside and outside before
you take the tent down. The tent must be
dismantled in the reverse order to the manner
in which it has been erected.
˜ Packing the tent together
m
CAUTION! Please ensure that the tent is
completely dry before you pack it together.
Otherwise this may result in stains and
damage to the fabric.
m
CAUTION! The tent pegs 5 and other
individual parts must be packed separately
in the bags provided. Otherwise the tent
pegs might damage the tent.
Always fold the tent together in such a way
that the floor of the tent is facing outwards.
Collect all of the parts together carefully
before you pack the tent. You should count
the parts in order to ensure that none of them
have been mislaid or lost.
After the tent has been rolled up, pack it
carefully into the carrying bag.
˜ Cleaning and care
m
CAUTION! Never wash the tent in a
washing machine. Otherwise the product
may lose some of its ability to keep out water.
m
CAUTION! Never use petrol, solvent or
other cleaning agents. Otherwise there is a
risk of damage to the product.
Condensation can form in all synthetic tents;
you should therefore air the tent as frequently as
possible in order to counteract this.
Remove any dirt from the tent with a soft
sponge and clean water.
Please allow all parts to dry thoroughly
before you repack the tent. This will prevent
the formation of mould, bad odours and
discolouration.
If the zipper sticks when being opened or
closed, spray it with silicone spray.
The product may lose some of its ability to
keep out water with frequent use. Therefore
you should spray the tent regularly with a
waterproofing agent (available in DIY shops,
camping shops etc.).
Store the product in a cool dry area.
GB/IE/NI
7
Publicité
