Télécharger Imprimer la page

Homelite UT80522F Manuel D'utilisation page 16

Publicité

Les langues disponibles

Les langues disponibles

SELECTING THE RIGHT NOZZLE FOR THE
JOB
See Figure 15.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more information
about which nozzle to choose.
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to heed this warning could cause personal injury.
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
To connect a nozzle to the spray wand:
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.
 Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
ABRASIVE
Concrete, Brick, Masonry
siding, gutters, House
Fencing, Deck, Patio
Lawn equipment, Boat, rV
OPERATION
NOZZLE SELECTION GUIDE
0º red
GENTLE
 recommended Nozzle
Page 12 — English
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle storage area on the top of the spray wand.
USING THE HIGH PRESSURE HOSE
The high pressure hose features an outer covering that
provides strength to the hose. If the outer covering becomes
damaged, the hose must be replaced immediately. Do not
use a high pressure hose if the outer covering is damaged.
To prevent damage to the outer covering:
 Inspect the hose before every use.
 Fully unwrap and straighten hose before use.
 Do not allow the high pressure hose to be kinked.
 Keep hose away from hot surfaces and sharp edges.
 Do not pull unit by high pressure hose.
 Do not allow hose to be crushed or wrapped around
objects.
HigH Pressure
(No soaP WHeN usiNg THese NoZZLes)
25º green
use With Caution for Certain applications
LoW
Pressure
(For soaP or
geNTLe riNse)
40º White
Blue soap Nozzle

Publicité

loading