Husqvarna PW 130 Manuel D'utilisation page 15

4. Remove the garden hose adapter in the opposite
sequence.
Introduction
WARNING:
safety chapter before you use the product.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
To install the spray handle
1. Push the high-pressure water hose into the quick
connection until it locks in position. (Fig. 17)
CAUTION:
make sure that the high-pressure hose
is fully connected to the quick connection
on the product.
2. Hold the spray handle tightly with one hand and
push the high-pressure water hose into the quick
connection on the spray handle. (Fig. 18)
To remove the spray handle
1. Push the button on the spray handle and pull out the
high-pressure water hose. (Fig. 19)
2. Push the outer ring on quick connection and pull out
the high-pressure water hose. (Fig. 20)
To install the spray lance
1. Hold the spray handle with one hand and push the
coupling on the spray lance into the spray handle.
(Fig. 21)
1839 - 009 - 24.05.2024
Operation
Read and understand the
To prevent leakage,
To install the holder for the spray
handle and the spray lance
• Install the holder with the 2 screws. (Fig. 16)
2. Turn the spray lance clockwise and release the
spray lance. The spray lance locks in position.
To remove the spray lance
1. Push in the spray lance and turn it counterclockwise.
(Fig. 22)
2. Pull out the spray lance from the spray handle.
To install and remove a nozzle
The product is supplied with 2 nozzles: 1 nozzle with
a straight water jet (identified with "gentle nozzle") and
1 rough nozzle with a rotating water jet (identified with
"rough nozzle". The nozzle with a straight water jet
can be used to clean sensitive surfaces, for example
vehicles. The rough nozzle can be used to clean
surfaces that are not sensitive, for example driveways.
(Fig. 23)
CAUTION:
a rotating water jet on sensitive surfaces, for
example painted surfaces on a vehicle. The
rotating water jet can cause damage to the
surface.
• To install a nozzle, hold the spray lance with one
hand and push in the nozzle until it locks in position.
(Fig. 24)
• To remove a nozzle, push in the tab on the spray
lance and pull out the nozzle from the spray lance.
(Fig. 25)
To adjust the pressure of the water jet
The nozzle with a straight water jet has adjustable
pressure.
• To increase the pressure of the water jet, turn the
nozzle clockwise. (Fig. 26)
• To decrease the pressure of the water jet, turn the
nozzle counterclockwise. (Fig. 27)
To operate the product
1. Connect the product to a water source. Refer to
connect the product to a water source on page 16 .
2. Bleed the system. Refer to
page 16 .
3. Start the product. Refer to
page 17 .
Do not use the nozzle with
To bleed the system on
To start the product on
To
15