BETEX BLF Serie Manuel D'utilisation page 21

Models with vertical yoke:
1. Remove dirt, burrs, etc., from the yoke and poles and lubricate lightly.
2. Place the yoke in front of the poles.
3. Loosen the bolts on the yoke by about half a turn.
4. Switch on the heater by pressing start. The yoke now sets itself. If necessary, a plastic
(dead blow) hammer may be used.
5. When noise reduces, then tighten all bolts and switch off the heater.
3
WARNING!
• Carrying out the right maintenance and following the instructions is important.
• Contact your supplier if in doubt about the correct functioning of the device.
• Repairs must be carried out by the manufacturer or a specialist approved
by the manufacturer.
© BETEX Tools
4
EN
DE
ES
FR
NL
5
21