BETEX BLF Serie Manuel D'utilisation page 16

7�1 Heating a hanging workpiece
• Place the induction yoke with the bearing on the poles. Make sure that the bare metal side
is positioned straight on the poles.
• Always choose an induction yoke that fills the bore of the bearing as much as possible.
You can even use 2 yokes at the same time. This promotes optimal, fast and even heating.
• Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
• Swivel arm models: swivel the yoke open (towards you) until it clicks in the safety
positioning cam. Slide the workpiece over the yoke until it is in the middle. Swivel the yoke
back to the pole.
• Always make sure that the workpiece does not come into contact with the plastic casing
of the heater. When the heating is finished, follow the instructions in reverse order. Use
heat-resisant gloves to move the heated workpiece.
16 © BETEX Tools