Publicité
Les langues disponibles
Les langues disponibles
7�2 Heating a horizontal workpiece
• This is only possible if the bore of the workpiece is large enough to fit over the pole.
• Place the workpiece as centrally as possible around the pole on the horizontal supports.
• The workpiece may not be wider than the horizontal supports.
• Always choose the largest induction yoke.
• Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
• Always make sure that the workpiece does not come into contact with the plastic casing of
the heater.
• When the heating is finished, follow the instructions in reverse order. Use heat-resistant
gloves to move the heated workpiece.
7.3 Maximum weights for swivel arm models
Table for maximum permitted weights on the horizontal support and the (swivel) yokes:
On
Type
supports
BLF 200
-
BLF 201
50 kg
BLF 202
100 kg
BLF 203
150 kg
BLF 204
200 kg
BLF 205
400 kg
BLF 206
600 kg
BLF 207
800 kg
BLF 208
1600 kg
• Keep to these maximum weights and avoid tilting the heater or damaging the supports,
(swivel) yokes or hinge.
CAREFUL!
Always handle induction yokes with care. They are damaged easily when dropped,
knocked against something, etc. Store them immediately after use.
© BETEX Tools
7
10
14
20
1 kg
2 kg
3 kg
5 kg
1 kg
2 kg
3 kg
5 kg
-
2 kg
3 kg
5 kg
-
-
-
10 kg
-
-
-
10 kg
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Size of (swivel)yokes (mm)
30
40
50
-
20 kg
-
10 kg
15 kg
-
10 kg
15 kg
20 kg
15 kg
25 kg
40 kg
45 kg
15 kg
25 kg
40 kg
45 kg
-
-
-
60 kg
-
-
-
60 kg
-
-
-
-
-
-
60
70
80
90
-
-
-
-
-
-
-
-
-
-
-
-
50 kg
-
-
50 kg
-
-
-
80 kg
-
-
-
80 kg
-
-
-
-
-
-
-
-
17
EN
DE
ES
FR
NL
Publicité
