Risco industrial LuNAR DT AM Grade 3 Guide D'installation page 23

Troubleshooting
This section describes possible system problems and their solutions:
Always perform the following preliminary checks before referring to the troubleshooting table:
Perform a complete visual inspection of the Ind. LuNAR RK200DTG3, for signs of mechanical
damage, loose connections or torn wires.
Check the connections of the incoming AC power source.
Trouble
ProSYS Configuration of
detectors fails/not accepted by
the system
Tamper indication while working
in the BUS mode
Tamper indication in the Relay
or BUS mode
Walk test cannot be initiated via
the ProSYS keypad
Green LED doesn't operate
during Walk test - MW channel
does not function
Meaning
ID configuration Disconnect all power sources,
problem configure the desired IDs and
reconnect power again
Tamper Verify that both DIP 8 and 9 are in
connection ON position
malfunction
Tamper probably Visually verify that ceiling tamper
not closed and spring are correctly installed
Wrong code Insert the appropriate code
Ind. LuNAR Normal behavior
RK200DTG3 is
configured (via
the ProSYS) to
the "MW disable
on DISARM"
during ProSYS's
DISARM mode
Ind. LuNAR Reset the detector.
RK200DTG3 If MW channel trouble reoccurs,
operating in replace the detector with a new one
Bypass mode
due to "Bypass
MW channel
mode"
Ind. LuNAR RK200DTG3 Installation Guide
Response
21