Use With Remote Control; Initial Pairing With The Remote Control - Oxypharm Nocospray 2 Manuel D'utilisation

If necessary, the device may be stopped during treatment by pressing
the button at the centre of the keypad again.
Respect the safety information provided on page <EX>.
4.3.2

Use with remote control

The remote control allows the device to be launched from outside of the room.
4.3.2.1
Before using the remote control for the first time, it needs to be paired with the NOCOSPRAY 2 device. Follow
the steps below:
Steps Action
1
Plug in the NOCOSPRAY 2 power cable.
Set the power switch to "0".
2
Press the button on the remote control (approx. 5 seconds) in direct
proximity to the NOCOSPRAY 2 with which you wish to pair it, hold the
button until the LED on the remote control begins to blink.
3
Keep the button on the remote control held down.
Turn on the NOCOSPRAY 2 to be paired by setting the power switch to
"1".

Initial pairing with the remote control

Illustration
EN
41