Oxypharm Nocospray 2 Manuel D'utilisation page 39

4. USE
4.1 Positioning of the device
The Nocospray must be placed on a flat and solid surface, ideally in a corner of the room to be treated and in
an elevated position, if possible
Before beginning a treatment, check that there is no obstacle within 1,5 metres of the nozzle tip.
4.2 Installation of the bottle
The installation of the bottle is carried out in the manner below.
Consider dating the product bottle before installing it onto the NOCOSPRAY 2.
Always check that the bottle contains a sufficient amount of product for the desired treatment (the device does not
indicate this).
Please refer to the attached table on page 54.
Steps Action
1
Remove the diffuser nose by pressing the release button.
2
Screw the product bottle (after dating it) onto the diffuser nose.
Do not screw it too tight in order to avoid irreversibly damaging the
joint.
3
Place the diffuser nose back onto the device.
You should hear a "click".
Illustration
CLIC !
EN
39