Oxypharm Nocospray 2 Manuel D'utilisation page 45

Steps Action
2
Turn your finger in a
keypad up to the value 1000, then carry out at least 3 supplementary
rotations.
3
The programmer mode is engaged with 3 LEDs are illuminated in the
following manner:
• the LEDs 100 m
• the LED 250 m
4
Select the desired volume by turning in an
(*) In programmer mode, the volume selected by default
is 1000 m .
3
The selected volume is displayed only when you touch the keypad.
5
Set the power switch to "0".
Unplug in the NOCOSPRAY 2 power cable.
6
Connect the NOCOSPRAY 2 to the programmer.
Plug the programmer into a mains socket.
Set the power switch to "1".
7
Refer to the programmer's notice to program it.
NB: it is possible to program it beforehand.
clockwise
direction on the pale part of the
and 500 m are illuminated,
3 3
is blinking.
3
anticlockwise direction (*).
Illustration
x3
EN
45