Lotus PC-74ET Instructions Pour L'installation Et L'emploi page 19

Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription, ECI norms.
The appliance is supplied without the connection cable. To install the power supply cable, proceed as follows:
•
Disconnect the power supply.
•
Remove the front panel
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
Block the cable with the cable blocker, and reassemble the front panel. The earth wire must be longer than the
others so that if the cable blocker should break, it will disconnect after the tension wires.
N.B. The connection cable must have an adequate section for the power of the appliance (see technical data table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance for the first cooking, it is necessary to clean it carefully, (see paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
The first time the hotplate is used, it is advisable to turn on for a few minutes, and at maximum power, all the hotplates,
in order to dry out any humidity in the insulating mass of the elements. The first time the oven is used, it is advisable to
take out all the removable parts and to heat it up to a temperature of 250°C.
Attention: - Use the appliance only under surveillance.
- Never turn on the electric hotplate without a pan;
- The pan must have a smooth bottom with an adequate diameter for the hotplate (never smaller).
Indications: - Each hotplate is connected to a commutator (selector) with 6 positions to allow to choose from 6
different temperatures.
- Each hotplate is provided with a temperature limiter which interrupts the electrical current as soon as
450°C is reached.
Any kind of food (meat, legumes, fish, rice, eggs, vegetables, etc.) can be cooked on the hotplates, providing suitable
pans are used.
Hotplates: Switch on the main switch installed above the appliance. Turn the control knob corresponding to the
hotplate from position "0" to the degree of coking desired, between 1 and 6. The light comes on, as son as the power
supply is on. It is advisable to turn on the hotplate at maximum temperature and, as soon as this is reached, turn the
control knob to the level desired. To turn off the hotplate, turn the knob back into position "0".
GB
LAWS, TECHNICAL RULES AND NORMS
ELECTRIC CONNECTION
EQUIPOTENTIAL
symbol.
STARTING UP
INSTRUCTIONS FOR USE
TURNING ON
IE
19