SPM Frosty2 Manuel D'utilisation Et D'entretien page 38

Problem
The auger is creating
noise as it rotates
The CUT OUT light on
the right side panel is on
Date d'émission : Janvier, 2019
Possible cause
The bell shaped shaft seal has been
•
replaced without lubrication or is
damaged
The auger has been incompletely or
•
incorrectly reassembled
The filter is dirty and needs to be
•
cleaned
The unit is positioned too close to a
•
wall or other object restricting air
flow and causing the machine to
run at a higher temperature
The filter is not properly installed
•
The unit has been installed near a
•
heat source, such as a coffee
machine, ice maker or cold
beverage machine which expels hot
air from its vents, causing the
machine to run at a high
temperature.
Replace or clean and lubricate with the
•
lubricant provided with the machine
Check and correct
•
Clean and replace filter following
•
instructions
Reposition unit to maximize ventilation
•
space (see installation figures)
Properly install filter see
•
Reposition unit to maximize ventilation
•
space (see installation figures)
Révision: 2
Solution
Page : 38/60