HoMedics FB-50J Manuel D'utilisation page 6

INSTRUCTIONS FOR USE
1. Ensure that the unit is unplugged before filling with water. Fill with water to the max
fill line located on the inside of the tub.
Do not fill water over the max fill line.
NOTE:
• THE FOOTBATH WILL NOT HEAT COLD WATER. FOR A WARM WATER
MASSAGE, FILL THE UNIT WITH WARM WATER.
• DO NOT PUT SOAP, SALTS, OR OTHER ADDITIVES INTO THE WATER IN THIS
FOOTBATH. THEY MAY CAUSE YOUR FOOTBATH TO MALFUNCTION.
2. Plug the unit into a 120-volt household outlet.
3. The footbath comes with 3 interchangeable foot massage attachments (Fig. 3).
Place the attachment that you desire into the center node slot (Fig. 1). Replace
unused massage attachments on front of footbath (Fig. 2).
4. Press power p button once to turn on bubbles (Fig. 1).
5. While seated, place your feet in the footbath.
6. Enjoy a deep soothing massage by sliding feet back and forth over the raised nodes
on the footbath floor or over center massage node.
7. Enjoy a dry foot massage by sliding feet back and forth over the raised nodes on the
splash guard.
8. When finished, press power p button once.
9. To empty: First, unplug the unit. Tip the unit, allowing water to pour out along the
rear corner of the footbath. DO NOT pour water over the power p button (Fig. 1).
NOTE: DO NOT hold or carry the unit by the removable splash guard.
NOTE: This unit can only run with water in it. DO NOT use without water.
6