Télécharger Imprimer la page

Pfannenberg DTS 6301C Serie Manuel D'utilisation page 57

Masquer les pouces Voir aussi pour DTS 6301C Serie:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB
DTI cooling unit switch cabinet assembly (installation)
Item
Designation
1
Catch spring
3
DTI cooling unit
4 B
Housing - cut-out
6
Switch cabinet wall / switch cabinet door
 The film for DTI cooling units with assembly instructions is available
Switch cabinet assembly
Requirements
-
The cut-out for the DTI cooling unit has been made; see the figure
-
The cooling unit is de-energized.
Required tools and material
-
Assembly tool, fastening springs (2)/(5) (accessory kit)
Procedure
 Fit the cooling unit (3) in the cut-out from outside; see the figure DTI cooling unit assembly.
 Push the cooling unit (3) into the switch cabinet (6) until the unit seal is applied.
 The catch spring (1) on the top side of the unit audibly engages. The cooling unit (3) is now secured from falling
out.
 Engage the fastening springs (2)/(5) on the inside of the switch cabinet (6).
 Press the fastening springs in with your hand so that the retaining bracket engages in the housing cutout (4 A).
 Use the fastening springs in the rear housing cut-outs (4B) for switch cabinets with reinforcement frame.
 Mount the cooling unit (3) so that the emergency condensate drain is arranged at the bottom of the unit.
Operating Manual DTS and DTI 6201C / 6301C Standard Controller (SC) 086100015 © Pfannenberg GmbH
1
2
3
4 A
4 B
5
6
Figure12 – DTI cooling unit assembly
Item
Designation
2
Fastening spring (top)
4 A
Housing - cut-out
5
Fastening spring (bottom)
HERE.
DTI cooling unit
assembly.
Page 19 / 38

Publicité

loading

Ce manuel est également adapté pour:

Dts 6201c serieDti 6201c serieDti 6301c serie