Publicité
Les langues disponibles
Les langues disponibles
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to
a threaded 3/4(inch) connector and
make sure that it is fastened tightly in
place.
If the water pipes are new or have not
been used for an extended period of
time, let the water run to make sure
that the water is clear. This precaution
is needed to avoid the risk of the
water inlet to be blocked and damage
the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its
intervention by blocking the flow of water in case of the supply hose breaking and
when the air space between the supply hose itself and the outer corrugated hose is
full of water.
WARNING
A hose that attaches to
line as the dishwasher. If your sink has one, it is recommended that the
hose be disconnected and the hole plugged.
How to connect the safety supply hose
1. Pull
the
safety supply hoses out from storage compartment located at
rear of dishwasher.
2.
Tighten
the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn
the
water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
ordinary supply hose
a tap
can burst if it is installed on the same water
18
safety supply hose
Publicité
