Publicité
Les langues disponibles
Les langues disponibles
us_main.book.book Page 13 Thursday, February 25, 2021 1:28 PM
hose can result in flooding and property
damage.
NOTE
• The drain must be installed in accordance with
any applicable local codes and regulations.
• Make sure that the drain hose is not stretched,
pinched, crushed, or kinked.
• The end of the drain hose should be located a
minimum of 24" (61 cm) and a maximum of 96"
(244 cm) above the bottom of the washer.
• For best results, locate the end of the drain hose
no higher than 66" (168 cm) above the bottom
of the washer. As the drain outlet is raised
beyond 66" (168 cm), the drain function will be
increasingly affected.
• Never create an airtight seal between the hose
and the drain with tape or other means. If no air
gap is present, water can be siphoned out of the
drum resulting in poor wash/rinse performance
or clothing damage.
Using a Standpipe to Drain
1
Clip the end of the hose into the elbow
bracket.
• Connect the elbow bracket
inches (10 cm) of the end of the drain hose.
If the drain hose is extended more than 4
inches (10 cm) beyond the end of the elbow
bracket, mold or microorganisms could
spread to the inside of the washer.
2
Insert the end of the drain hose into the
standpipe.
3
4
Using the Laundry Tub to Drain
1
within 4
a
4 "
(10 cm)
2
INSTALLATION
Use the provided tie strap
b
drain hose in place.
If the water valves and drain are built into the
wall, fasten the drain hose to one of the water
hoses with the provided tie strap
side on inside).
24 - 96 "
(61 - 244 cm)
Clip the end of the hose into the elbow
bracket.
• Connect the elbow bracket
inches (10 cm) of the end of the drain hose.
If the drain hose is extended more than 4
inches (10 cm) beyond the end of the elbow
bracket, mold or microorganisms could
spread to the inside of the washer.
(10 cm)
Hang the end of the drain hose over the side
of the laundry tub.
13
to secure the
(ribbed
c
24 - 96 "
(61 - 244 cm)
within 4
a
4 "
Publicité
