• On/Off switch (14)
• Switching on: Press
• Switching off: Release
Screwing on the base
Procedure (Fig. A)
• Screw the base (10) onto the thread
socket.
Tighten the base only hand-tight.
Attaching/removing the
high-pressure hose
Attaching the high-pressure hose
(Fig. B)
1. Insert the connection for the telescop-
ic tube (23) into the connection for the
high-pressure hose (8).
It will lock into place.
Dismantling the high-pressure
hose (Fig. B)
1. Press the release (9).
2. Pull the high-pressure hose (25) off the
connection for the high-pressure hose
(8).
Attaching/removing the flat
spray nozzle
Attaching the flat spray nozzle
(Fig. C)
• Fix the flat spray nozzle (1) by inserting
and turning it (Bayonet locking device)
at the elbow connector (2).
Removing the flat spray nozzle
(Fig. C)
• Remove the flat spray nozzle (1) by
pressing, turning and pulling it out
(Bayonet locking device) from the el-
bow connector (2).
Operation
Working instructions
WARNING! Risk of injury! Be aware
of the recoil force when the water jet com-
mences. Ensure you are standing firmly
and holding the spray gun firmly. Other-
wise there is a risk of injuring yourself or
other people.
• Connect a pressure washer to the wa-
ter connection (11) of the lance.
• Put the shoulder strap (17) on.
• Hold the lance with both hands on the
handle (13) and on the insulated grip
(6).
Telescoping the lance
Procedure (Fig. C)
1. Release the locks (18).
2. Pull out the extension arms (4) to the
desired length.
3. Fix the extension arms in place with the
locks.
Adapter with threaded
connection
The adapter (22) is intended for
use with the following PARKSIDE-
Pressure washers: PHD 100 A1,
PHD 100 B2, PHD 100 C2,
PHD 100 D2, PHD 110 D1, PHDS 110
A1 Silent, PHD 150 A1, PHD 150 B2,
PHD 150 C2, PHD 150 D3,
PHD 170 A1, PHD 170 B2,
PHDP 180 A1.
Procedure (Fig. D)
1. Insert the adapter (22) into the water
connection (11).
You will hear it click into place.
2. Connect a pressure washer to the wa-
ter connection via the adapter.
IE
NI
7