Télécharger Imprimer la page

DoorBird D2104V Manuel D'installation page 8

Publicité

Les langues disponibles

Les langues disponibles

An image sensor must not be exposed to
N OT IC E
direct sunlight for an extended period of time.
Direct sunlight will "blind" the camera and
may permanently bleach the small color filters
on the image sensor chip.
Any defects caused by direct sunlight are not
covered by warranty.
The network cable between the device and the
PoE-Switch/PoE-Injector/Internet Router can have a
maximum length of 80 meters/262 feet (IEEE 802.3).
If you have only two wires available at the
assembly location, you may use of the
"DoorBird 2-Wire Ethernet PoE Converter
A1071", sold separately. It allows you to
transfer network data (Ethernet) and power
(PoE) with a simple two-wire cable over
long distances. For example; existing buil-
dings with a simple two-wire bell wire can
be equipped with network technology wit-
hout having to retrofit any network cables.
4
REMOVING THE FRONT PANEL
Remove the front panel carefully using the screw
driver provided with the device from the mounting
housing (backbox).
1.)
Turn out the
security screws
for 1 cm
ASSEMBLING THE MOUNTING
5
HOUSING
Assemble the mounting housing (backbox) to the wall.
You can find detailed drawings and measurements of
the device in the corresponding datasheet.
If you must drill holes in a wall, insert screws
into a wall or lever up a wall, ensure that
no cables or mains (gas, water, etc.) are to be
found in the wall.
8
2.)
3.)
Pull down the
Pull the front
front panel.
panel towards
you.
Mounting the surface-mounted housing
Place the rubber seal for the cable entry on the
mounting opening.
Pierce through the
middle of the rubber
seal using a
screwdriver.
6
POWER SUPPLY OPTIONS
The device can be powered using the DoorBird pow-
er-supply unit (mains adaptor) (Option 1) or via PoE
(Power over Ethernet) using a network cable (Option
2). The device can be alternatively also be supplied
with power using a DIN-rail power supply unit that
you can obtain direclty from us.
The device does not use battery power.
OPTION 1
Power supply using the power supply unit
(mains adaptor)
The power supply unit (mains adaptor) has a 300 cm
long cable with two insulated wires.
Do not plug the power supply unit into the
N OTICE
wall socket yet. Only use the original
DoorBird power supply unit or a DIN-rail
power supply unit that you can obtain from us
separately, since this has been specially
stabilized electrically and is equipped with
an integrated audio inter ference reduction
device. Other power supply units may
destroy the device or cause poor
transmission quality. The warranty expires
automatically if you use a different power
supply unit.
Rubber seal for cable
entry
Cover for unused
openings
Feed all cables and wires
that you want to connect
to the device through
the rubber seal.

Publicité

loading

Ce manuel est également adapté pour:

D21 serieD2103vD2101fv ekeyD2105v