Publicité
Les langues disponibles
Les langues disponibles
2
Adjustment of brake calipers
If the distance between the brake rubber and the wheel rim is large, turn the
adjusting screw counter-clockwise and then tighten the adjusting nut. Conversely,
turn the fine adjustment screw clockwise (For details, please refer to general use,
maintenance and simple repair of bikes). If the brake rubber is left or right, use a
thin wrench to adjust the milled flat part of the center seat, hold the brake handle
to make the two brake legs swing at the same time, so that the gap between the
wheel rim and the left and right brake rubber is equal. The clearance between the
forklift block and the upper edge of the rim is 1-2 mm, and it is parallel to the rim.
4
Install the front wheel
Front fork
Nut
Hook
Front wheel
08
This item is applicable to the
packaging method without assembling
the front wheel
Install the front wheel into the front fork,
put on the safety hook and nut in turn,
adjust the gap between the wheel and the
front fork leg to be equal, and then tighten
the nut (The screwing torque of 3/8 core
is 30N.m or more, and 18N.m or more of
5/16 core).
5
Fixing the training wheels
Remove the protective caps on the axle of the rear wheel. Unscrew the nuts, and
put the training wheel on. Then screw on nuts again.
Note: Before the nuts are fully tightened, you can adjust the training wheel up or
down to make the bottom of the training wheel have a clearance less than 0.2"
(5mm) up from ground.
Tighten the nut, the torque is not less than 30N.m
IMPORTANT
1. For safety, the nuts should be screwed tightly.
2. The ear of the positioning washer should be fixed in the clearance of the
rear fork.
6
Fixing the Pedals
Check the end of the
Pedals and find out which
one is for the left and
which one is for the right.
Screw the right Pedal to
the right crank and
tighten it. Then fix the left
Pedal.
"R": for right
"L": for left
positioning
washer
09
Publicité
