Publicité
Les langues disponibles
Les langues disponibles
EN
6.8. PREEENTION OF FIRE.
•
During the welding process, the metal is heated to very high temperatures and sparks and slag
may be projected. Appropriate precautions must be taken to prevent fires and/or explosions.
•
Avoid working in areas with containers of flammable substances.
•
All fuels and/or combustible products must be kept far away from the work area.
•
Extinguishers should be located nearby and accessible.
•
Special precautions must be taken when welding:
➢ containers that have contained flammable substances.
➢ inside metal containers or in places with little ventilation.
•
These operations must always be carried out with the presence of qualified staff who can
provide the necessary assistance if required.
•
NEVER work in environments whose atmosphere contains flammable gases or combustible
vapors (such as oil or its vapors).
6.9. EXTENSION CORD.
•
Replace damaged cables immediately. The use of damaged cables can result in electric shock,
burns or electrocution.
•
Shall an extension cable be necessary, it must be used with the appropriate size of conductors
and an admissible power equal to, or greater than that indicated on the nameplate of the
machine or in this manual.
•
The extension cable must have a ground conductor and be connected to a power source with a
ground connection.
7. TECHNICAL SPECIFICATIONS.
TECHNICAL DATA
VOLTAGE / FREQUENCY.
NOMINAL INPUT CURRENT.
WELDING OUTPUT INTENSITY.
WELDING OUTPUT VOLTAGE.
GEAR FACTOR (*).
POWER FACTOR.
ENERGY EFFICIENCY.
WIRE SPEED (m. / min.).
DIAMETER OF THE THREAD COIL. (mm.)
THREAD DIAMETER. (mm.)
ELECTRODE DIAMETER (mm.)
DEGREE OF PROTECTION.
INSULATION CLASS.
WEIGHT (Kg.)
DIMENSIONS (mm.)
(*) Note: The welding duty cycle is the percentage of actual continuous welding time that can occur in a ten minutes
cycle. For example: 40% at 130amps- this means the welder can weld continuously at 130 amps for 4minutes and
then the unit will need to be rested for 6 minutes.
The duty cycle can be affected by the environment in which the welder is used. In areas with temperatures
exceeding 40℃, the duty cycle will be less than stated. In areas less than 40 ℃, higher duty cycles have been
obtained.
All tests on duty cycles have been carried out at 40℃ with a 50%. So in practical working conditions the duty cycles
will be much greater than those stated above.
CE-PROMIG130N
MIG/MAG
1~ 230V. – 50/60Hz.
10,6A.
30 – 130A.
15,5 – 20V.
2 - 13
150
0,8 – 1,0
345x155x320
53
MMA
TIG
13,1A.
7,8A.
20 – 130A.
10 – 130A.
20,8 – 24,8V.
10,4 – 14,8V.
40%
0,73
85%
3,25max.
1,6max.
IP21S
F
6,2
Publicité
