Tesla RC3400FMX Mode D'emploi page 8

ENG
8. Remove the upper left hinge cover and upper left hinge from the accessory bag.
Place the refrigerated door body on the middle hinge and install the upper left hinge.
Connect the refrigerator top signal line 4 to the door body signal line 1, and connect the signal line 2 to
the signal line 3.Finally, replace the hinge decorative cover to the right side of the box body (note: when
replacing the hinge decorative cover to the right side of the box body, the two inserts on the hinge
decorative cover (as shown in the figure) shall be cut o).
Changing the Light
Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer,its service
agent or similar qualified person.
Light source in this product is replaceable only by qualified engineers.
Starting
• After transportation, please let the product stay for more than 2 hours before turning on the power,
otherwise it will lead to a decrease in cooling capacity or a damage to the product.
• Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3 hours, or for above 4
hours in summer when the ambient temperature is high.
• Please pull out the plug in case of power failure or cleaning. Do not connect the freezer to power
supply within five minutes to prevent damages to the compressor due to successive starts.
Energy saving tips
• The appliance should be located in the coolest area of the room, away from heat producing appliances
or heating ducts, and out of the direct sunlight.
• Let hot foods cool to room temperature before placing in the appliance. Overloading the appliance
forces the compressor to run longer. Foods that freeze too slowly may lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance. This cuts
down on frost build-up inside the appliance.
• Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners
interfere with cold air circulation, making the appliance less efficient.
• Organize and label food to reduce door openings and extended searches. Remove as many items as
needed at one time, and close the door as soon as possible.
upper hinge
(The picture above is only for reference.The actual configuration will
depend on the physical product or statement by the distributor)
1. Please take out
the plug before
removal.
3. Take down the
lamp panel.
upper hinge cover
2. Remove the lampshade
with a screwdriver.
4. Remove the connection
terminal.
8
decorative cover
inserts