Hotpoint LFF 8S112 Mode D'emploi page 25

Special wash cycles and Options
Notes:
Optimum performance levels when using the "Fast wash"
and "Express 30'" cycles can be achieved by respecting the
specified number of place settings.
*
The Eco wash cycle complies with regulation EN-50242.
Although it has a longer duration than other wash cycles, it uses
less energy and is less harmful to the environment.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
ASSISTENZA_EN_LVS@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Delayed start
It is possible to delay the start time of the cycle by
1 to 24 hours:
1. Select the desired wash cycle and any other options
required, press the DELAYED START button. The relevant
symbol starts flashing. Use the buttons + and - to select when
the wash cycle will start (h01, h02 etc.)
2. Confirm with the START/PAUSE button. The symbol stops
flashing and the countdown begins.
3. Once this time has elapsed, the DELAYED START symbol
switches off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text OFF appears.
The Delayed Start function cannot be set once a wash
cycle has been started.
Short Time
This option can be used to reduce the duration of
the main wash cycles while, maintaining the same washing
and drying performance levels. After selecting the wash
cycle, press the SHORT TIME button; the illumination of the
corresponding indicator light indicates its selection. Press
it again to deselect it.
(see Table of wash cycles)
, the
*
Extra drying
To improve the dryness level of the crockery, press
the EXTRA DRYING button and the symbol will light up. If it
is pressed again, the option will be deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration
of the wash cycle.
Multi-functional tablets
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol
will light up. If the button is pressed again, the option will
be deselected.
The "Multi-functional tablets" option results in a
longer wash cycle.
The use of tablets is only recommended for models
having this option and it is not recommended with wash
cycles which do not specify the use of multi-functional
tablets.
*
Zone Wash
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash
cycle and then press the ZONE WASH button: the selected
rack lights up and the wash cycle starts in the selected rack
only. Press the button again to deselect the option.
The option is available with the following wash cycles:
Intensive and Normal.
Select the option and the Intensive cycle to start the POWER
ZONE washing. This wash cycle is ideal for very soiled
mixed loads, e.g. pans and saucepans, dishes with heavy
encrustation or difficult-to-clean crockery (grater, vegetable
mill, dirty cutlery). The spraying pressure is stronger and
the washing temperature higher, thus ensuring optimum
handling of stubborn stains.
Select the option and the Normal cycle to start the GREEN
ZONE washing. This function makes it possible to reduce
water and energy consumption, thus achieving excellent
washing and drying results. Cycle duration is longer.
Remember to load the crockery in the selected rack only.
*
(Tabs)
25
EN