Hilti TE 500-A36 Mode D'emploi page 20

Trouble or fault
No response from
the LEDs on the bat-
tery.
1 LED on the battery
flashes.
4 LEDs on the bat-
tery flash.
Product does not
develop full power.
The insert tool can-
not be released from
the chuck.
Product does not
start.
Service indicator
shows.
Service indicator
flashes.
16 English
Possible cause
The battery is too hot or
too cold.
Battery is discharged.
The battery is too hot or
too cold.
Product momentarily
overloaded.
Protection against over-
heating.
The control switch is not
fully pressed.
The half-power button is
engaged.
The chuck is not pulled
back fully.
The side handle is not
fitted correctly.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
Service limit time
reached.
The product is faulty.
Action to be taken
▶ Bring the battery to
the recommended
working temperature.
▶ Change the battery
and charge the empty
battery.
▶ Bring the battery to
the recommended
working temperature.
▶ Release the control
switch and then press
it again.
▶ Allow the product to
cool down and clean
the air vents.
▶ Press the control
switch as far as it will
go.
▶ Press the "half-power"
button.
▶ Pull the chuck back
as far as it will go and
remove the accessory
tool.
▶ Disengage the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
▶ Switch the product off
and then on again.
▶ Have the product
repaired by Hilti
Service.
▶ Have the product
repaired by Hilti
Service.
2240496
*2240496*