Hilti TE 500-A36 Mode D'emploi page 12

down. If it is still too hot to touch after an hour, the battery is faulty.
Contact Hilti Service.
3 Description
3.1 Product overview
Chuck
@
Function selector switch
;
Lockbutton for sustained op-
=
eration (chiseling only)
Control switch
%
Charge-status and fault indi-
&
cator (Li-ion battery)
Release buttons (also used
(
to activate the charge status
indicator)
3.2 Intended use
The product described is a cordless (battery-powered) breaker with pneu-
matic hammering mechanism. The product designed for light to medium
chiseling work on masonry and surface finishing work on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these
batteries.
3.2.1 Possible misuse
• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.3 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which
reduces vibration noticeably.
3.4 Service indicator
The product is equipped with a service indicator LED.
3.4.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
8 English
1
)
+
§
/
:
∙
$
Meaning
Servicing is due.
Have the product repaired by Hilti
Service.
The product is switched on
Battery
Side handle
On/off switch
Button for half power
Half-power indicator
Service indicator
ON/OFF indicator
2240496
*2240496*