Hilti TE 500-A36 Mode D'emploi page 15

6.1.3 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
6.1.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Switch off the power tool.
2. Release the side handle clamping band by turning the handle grip.
3. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
4. Set the side handle to the desired position.
5. Tighten the side handle clamping band by turning the handle grip.
6.1.5 Setting the power level
After the battery is inserted, the product is always set by default to full
power.
1. Press the "button for half power". The product runs at half power.
▶ The "half power indicator" lights up.
2. Press the "button for half power" again. The product runs at full power.
▶ The "half power indicator" goes out.
6.1.6 Inserting / removing the accessory tool
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
The use of unsuitable grease can cause damage to the product. Use
only genuine Hilti grease.
1. Apply a little grease to the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the product.
2. Set the function selector switch to the "Chiseling" position
*2240496*
2
2240496
8
3
.
English 11