Hilti SF 10W-22 Mode D'emploi page 29

Installing auxiliary handle
1.Loosen the auxiliary handle holder (clamping band) by turning the handle grip (1). Slide the holder
(clamping band) over the keyless chuck from the front and into the recess provided (2).
2.Set the auxiliary handle to the desired position (3).
3.Tighten the auxiliary handle holder (clamping band) by turning the handle grip (4).
Operation
Observe the safety instructions and warnings in this documentation and on the product.
Adjusting auxiliary handle
1.Loosen the auxiliary handle holder (clamping band) by turning the handle grip (1).
2.Move the auxiliary handle to the desired position (2).
3.Tighten the auxiliary handle holder (clamping band) by turning the handle grip (3).
5
Selecting the gear
The gear selector switch can be operated only when the motor is not running.
1.Set the top gear selector switch to the position for forward rotation and use the bottom gear
selector switch to select either speed 1 or speed 2.
2.Set the top gear selector switch to the position for reverse rotation and use the bottom gear selector
switch to select either speed 3 or speed 4.
Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (switch-
on interlock).
▶
Set the forward/reverse switch to the desired direction of rotation.
7
Drilling
1. Set the torque and operating mode selector ring (1)to the
2.Set the forward/reverse switch to the "forward" position.
7
Screwdriving
1.Set the torque and operating mode selector ring to the required torque (1).
2.Set the forward/reverse switch to the desired direction of rotation.
Switching on and off
1.To switch the product on, press the control switch.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
2.To switch the product off, release the control switch.
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
*2369075*
3
4
6
2369075
symbol.
24