Hilti SF 10W-22 Mode D'emploi page 31

▶
Store the product and the batteries in a cool and dry place. Comply with the temperature limits
stated in the technical data
▶
Do not store batteries on the charger. Always remove the battery from the charger when the
charging operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶
Store the product and batteries where they cannot be accessed by children or unauthorized
persons.
▶
Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the
section headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem
by yourself, please contact Hilti Service.
Trouble or fault
Control switch cannot be
pressed or is stuck.
Product does not work.
The battery runs down
more quickly than usual.
The product or battery gets
very hot.
The battery does not en-
gage with an audible click.
LEDs of the battery show
nothing
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical tape) to prevent short
circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or
public health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, your old tools, machines
or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
*2369075*
21.
Possible cause
The forward/reverse switch is in
the middle position.
Battery not fully inserted.
Very low ambient temperature.
Electrical fault.
Retaining lug on the battery
dirty.
Battery faulty.
2369075
20
Action to be taken
▶
Set the forward/reverse switch
to the desired direction of
rotation.
▶
Push the battery in until it
engages with an audible click.
▶
Allow the battery to warm up
slowly to room temperature.
▶
Switch the product off imme-
diately, remove the battery,
keep it under observation,
allow it to cool down and
contact Hilti Service.
▶
Clean the retaining lug and
engage the battery in the
working position.
▶
Contact Hilti Service.
24
26