Publicité
Les langues disponibles
Les langues disponibles
Door Panel Preparation – Stainless Steel Panel
Door Panel Attachment Kit
Side bracket (10x)
Bracket slider (10x)
ATTACHING THE BRACKETS
Remove the blue tape attached to the
inner edges of the door panel before
attaching the brackets.
Peel protection film away from the
inner edges to avoid trapping under
the brackets.
Secure the top hanging bracket to the
screw holes of the door panel with
8Gx16 Mush washer screws (10x).
Secure the bracket spacer, side
bracket and bracket slider (in order as
illustrated) to the screw holes on both
sides of the door panel with 8Gx16
mush washer screws (20x). The side
bracket should be able to move freely
horizontally and vertically.
ATTACHING MINIMALIST / STATEMENT HANDLE
Remove the protective film around the handle attachment
area before installing the handle. Protect the finish of the
door panel to avoid damage or scratches to the surface.
Make sure the set screws in the handle caps are
loosened. Place the handle over the fasteners on the
door. Take care to support the handle so it doesn't fall
and scratch the appliance finish. Make sure both of the
handle caps are resting on the face of the door.
Lock one end of the handle into position by tightening
the set screw in the handle cap with the Allen wrench
provided in the handle kit. Be sure not to over tighten.
Keep supporting the handle as you lock the other end
of the handle into position by tightening the set screw
in the handle cap with the Allen wrench. Be sure not to
overtighten.
NOTE: 1/8" Allen Wrench is included in handle kit.
Bracket spacer (10x)
8Gx16 Mush washer screw (30x)
Top hanging bracket
24
24
Screws
From stainless steel door
panel and toe kick kit)
Bracket spacer
Side bracket
Bracket slider
Side bracket
Left side installation when facing
Right side installation when facing
Set screw
Required Tools
Powered driver - Cross-Head
rear of the door panel
rear of the door panel
Fastener
31-1000764 Rev. 0
Publicité
