Publicité
Les langues disponibles
Les langues disponibles
ATTACHING THE ANTI-TIP BRACKET
A
min 7 3/4"
(19.7cm)
bracket
31-1000764 Rev. 0
Anti Tip Hardware Installation
1
Measure the height
(A) of the attachment
location from the floor
to the alcove return.
• The height (A) must
not exceed 84 3/16"
(213.8cm) to ensure
the appliance does
not tip over during
installation.
2
Mark a horizontal line
(B) at the back wall.
• Ensure there is a stud
behind the wall.
B
3
Place the bracket to
the backwall. Align
the undersurface of
the bracket along the
marked line.
Mark screw hole
locations, and drill screw
holes with powered drill.
21
4
For solid wall
installation
Drill holes suitable to
the size of the masonry
plugs.
Hammer 10x30mm
masonry plugs into wall
until flush. Fix bracket
to wall with #10x35mm
cross head screws, and
screw tightly.
5
For plaster board wall
Fix the anti-tip bracket
to the wall with
#10x35mm cross
head screws, and
screw tightly with a
screwdriver.
When rollng the
appliance into the
cabinetry, ensure the
anti-tip bracket overlaps
the back edge of the
appliance.
• The bracket must
overlap the appliance
by a minimum
7 1/16" (18cm) for a
secure hold.
If minimum 7 1/16"
(18cm) overlap cannot
be achieved, install a
solid spacer to the wall
stud behind the bracket
• Be careful not to run
over the power cord
when rolling in the
appliance.
Publicité
