Publicité
Les langues disponibles
Les langues disponibles
WARNING
RISK OF EXPLOSION!
DO NOT OPERATE UNIT IN AN
AREA WHERE FLAMMABLE GAS
VAPORS MAY BE PRESENT. AN
ELECTRIC SPARK MAY CAUSE
AN EXPLOSION.
RISK OF BURSTING!
DO NOT STORE / OPERATE UNIT
IN A FREEZING ENVIRONMENT.
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
NEVER LOOK DIRECTLY AT THE
NOZZLE ORIFICE UNLESS IT
IS DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
WHEN USING THE ADJUSTABLE
NOZZLE, NEVER ADJUST THE
SPRAY PATTERN WHILE THE
TRIGGER GUN IS OPEN!
10
INSTALLATION & PREPARATION
ATTIRE:
Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin.
respiratory mask) may be required when using detergent cleaning agents with
this washer.
SETUP:
1. This unit should only be placed on a level surface to ensure proper lubrication
for the water pump while operating. NEVER spray water directly on the
unit!
2. Do not place unit in an area:
a. where there is evidence of oil or gas leaks.
b. where flammable gas vapors may be present.
3. Do not allow the unit to be exposed to rain, snow or freezing temperatures.
If any part of the unit becomes frozen; excessive pressure may build up in
the unit which could cause it to burst, resulting in possible serious injury to
the operator or bystanders.
4. Make sure the oil level is in the center of the sight glass. Pump oil
level should be checked before each use. If low, fill with Mi-T-M pump oil
(#AW-4085-0016). DO NOT OVERFILL!
NOZZLE REVIEW:
NOTE:
Nozzle assembly should NOT be connected to the gun assembly
at this time.
1. Selection of high pressure can be achieved by turning the protective collar
clockwise as shown in Figure 1, left. While in the high pressure mode,
water is directed solely through the 15° spray nozzle creating a concentrated
high pressure "fan" spray.
2. Selection of low pressure detergent application can be achieved by turning
the collar counterclockwise as shown in Figure 2, left. Once the pressure
is low enough, the detergent injector on the pressure washer will draw
detergent into the system. As the collar is turned, a water/detergent mixture
exits not only from the spray nozzle, but also around the nozzle. This creates
a "fan/cone" combination spray pattern.
Additional safety attire (such as
Operator's Manual
Publicité
