Publicité
Les langues disponibles
Les langues disponibles
HDMI output Jitter
Check your TV system setup correctly.
Checkpoint 1
Screen Jitter may occur when the
Checkpoint 2
frame rate is converted from 50Hz to
60Hz for 720p/1080i HDMI (High
Definition Multimedia Interface) Output.
Please refer to the user's manual of
Checkpoint 3
your TV.
Remote Control Unit
The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are empty.
Checkpoint 2
Check for the TV/DVD selection button.
Checkpoint 3
Other
I forgot my password for parental supervision.
Press the
Checkpoint 1
the Recorder for more than 5 seconds with
no disc in the DVD recorder. All settings
including the password will revert to the
factory settings. Do not use this unless
absolutely necessary.
(Note that this function is possible only
when no disc is inserted.)
Is it possible to change a subtitle and an audio sig-
nal on a recorded disc?
A recorded disc is played with only the
Checkpoint 1
subtitle and the audio signal which
were selected during recording.
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Checkpoint 2
Turn your DVD recorder off and on.
Checkpoint 3
If the problem still persists, contact a
nearby Samsung service centre.
button on the front panel of
91
English -
Publicité
