Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE WASHER
7. Attach U-shaped hose guide to the end of the drain
hose. Place the hose in a laundry tub or standpipe
and secure it with the cable tie provided in the
enclosure package.
NOTE: If the drain hose is placed in a standpipe
without forming a U shape, a siphoning action could
occur. There must be an air gap around the drain hose.
A snug hose fit can also cause a siphoning action.
Cable Tie
8. Plug the power cord into a grounded outlet.
NOTE: Check to be sure the power is off at a
circuit breaker/fuse box before plugging the power
cord into an outlet.
Installation Instructions
(cont.)
Cable Tie
Cable Tie
9. Turn on the power at a circuit breaker/fuse box.
10. Read the rest of this Owner's Manual. It contains
valuable and helpful information that will save you
time and money.
11. Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level and all four leveling legs are firmly
on the floor.
❏ The shipping support hardware is removed
and saved.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.
12. Run the washer through a complete cycle. Check
for water leaks and proper operation.
13. If your washer does not operate, please review
the Before You Call For Service section before
calling for service.
14. Place these instructions in a location near the
washer for future reference.
REPLACEMENT PARTS
If replacement parts are needed for your washer, they
can be ordered in the United States by visiting our
Website at ge.com or by calling 800.GE.CARES.
19
Publicité
