Publicité
Les langues disponibles
Les langues disponibles
Jandy
Cartridge Pool Filters | Installation & Operation Manual
®
Clamp Ring
"T" Nut and
Threaded Rod
Figure 9. Filter Clamp Ring
10. If desired, the CV filter drain can be plumbed using
a Jandy Pro universal union. The plumbing must
contain a ball valve as shown in Figure 6.
CAUTION
Be sure that all provisions for wastewater disposal
meet local, state or national codes. During any draining
process, one hundred gallons (100 gals.) or more of pool
water will be discharged. CL and CV (Cartridge) Filters
are not subject to backwashing. Do not discharge water
where it will cause flooding or damage.
3.5
Clamp Installation
1. Be certain the o-ring is in position in the lower
tank half. Press the filter lid over the lower half
sandwiching the o-ring between the two halves.
2. Holding the ends of the filter clamp apart, position
the hinged segment of the filter clamp over both
upper and lower tank flanges. Bring the ends of the
filter clamp together.
3. Place the "T" nut and threaded rod assembly into
the clamp. Be sure the "T" nut is seated in the
clamp in the proper orientation. See Fig. 9.
4. Use a 9/16" socket on the tightening nut until the
clamp ring halves touch each other, or are within
1/16", see Fig. 9 but do not overtighten as the
clamp can break. If unable to tighten as indicated,
do not operate the filter and call a service
technician immediately.
5. After the first week of operation, check the clamp
and retighten if necessary.
6. Check the filter clamp at least once a month.
Tightening Nut
w/ Shoulder
WARNING
Follow these instructions carefully. Improper
clamp installation can cause product failure
or also cause the filter lid to be blown off,
which can result in death, serious personal
injury, or property damage.
Section 4. Start-Up and Operation
NOTE: This section applies to both new pool and seasonal start-up.
1. Turn off the pump. Switch off the circuit breaker to
the pump motor.
2. Check that the drain plug for CL filters or drain cap
for CV filters is in place and tight.
3. Check that the tank clamp is correctly seated and
tight. See Figs. 9 and 10.
WARNING
NEVER start pump while standing within
five (5) feet of the filter. Starting the pump
while there is pressurized air in the system
can cause product failure or also cause the
filter lid to be blown off, which can cause
death, serious personal injury or property
damage.
NEVER operate the filter system at more
than 50 psi of pressure. Operating the filter
system in excess of 50 psi can cause the
product failure or also cause filter lid to be
blown off, which can cause death, serious
personal injury or property damage.
CAUTION
DO NOT operate filter at water temperatures above
105° F (40.6° C). Water temperatures above the
manufacturer's recommendations will shorten the life
span of the filter and void the warranty.
4. Open the pump hair/lint pot lid and fill the pump
basket with water to prime the system. Replace the
lid. (You may have to do this several times on new
and seasonal start-ups.)
5. Completely open the air release valve on the
gauge/air release assembly by turning the knob on
the back of the assembly fully counterclockwise (do
not remove the knob).
ENGLISH
Page 9
Publicité
