Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
#12x1" Pan Head
Stainless Steel
Screw (Qty 8)
Anchor
Bracket
(Qty 4)
Filter Tank Anchor Bracket Installation
Figure 3. Anchor Bracket Installation
Figure 4. Pressure Gauge/Air Release Assembly
5. To mount the pressure gauge/air release assembly
to the top of the filter tank (located in the accessory
bag):
a. Place the smaller, thicker o-ring onto the threads
of the tank adapter, see Figure 4. Slide the tank
adapter through the coupling nut and into the
filter tank. Use the flats on the tank adapter to
tighten. Do not overtighten.
b. Place the larger, thinner o-ring onto the gauge
housing. Thread the housing into the coupler on
the tank adapter.
c. Orient the gauge/air release assembly in the
desired position. Raise and thread the locknut
onto the bottom of the gauge/air release
assembly. Hand tighten the nut only. Using a
wrench to tighten the nut may damage the nut,
gauge or air release assembly.
Page 6
1/4" x 2-1/4" S.S. Tapcon
Screw and S.S. Washer
Tank Bottom
Housing
O-Ring
Tank Adapter
Tank Adapter to
Housing Coupler
O-Ring
Jandy
Cartridge Pool Filters | Installation & Operation Manual
®
#12x1" Stainless Steel Pan
Head Screws (Qty 2)
Drill Two 3/32" Holes
Through Filter Base
Mounting Bracket
®
Drill 5/32" Hole
Anchor Bracket to Platform Installation
3.4
Filter Plumbing
1. This filter operates under pressure. When clamped
properly and operated without air in the water
system, this filter will operate in a safe manner.
2. If the system can be subjected to higher pressure
than the maximum rating of any component, install
an ASME
approved automatic pressure relief valve
®
or pressure regulator in the circulation system.
Set the relief valve or pressure regulator to lowest
working pressure of any of the components in the
system.
3. Place the filter on the concrete pad, lined up with
the inlet/outlet pipes. See Figures 5 and 5A.
4. To reduce pressure losses, 2" (minimum) piping is
recommended for plumbing the system.
5. For best efficiency use the fewest possible number
of fittings. This will prevent a restriction in the water
flow.
5.1 The CV model filter comes with a Jandy Pro
Sweep Elbow for this purpose. The sweep
elbow also includes a threaded port and plug
so that a ½" hose bib can be connected for
pressure testing. See Figure 7.
5.2 To install the sweep elbow use the following
instructions:
To avoid an electrical shock hazard, which can result in
serious injury or death, ensure that all electrical power to
the system is turned off before approaching, inspecting
or troubleshooting any leaking valves or plumbing
that may have caused other electrical devices in the
surrounding area to get wet.
Filter Base
Mounting Tab
WARNING
3-1/2" Thick
(Min.)
Concrete Pad
Publicité
