Télécharger Imprimer la page

Jandy CL Manuel D'installation Et D'utilisation page 11

Publicité

Les langues disponibles

Les langues disponibles

Jandy
Cartridge Pool Filters | Installation & Operation Manual
®
Section 6. Maintenance
6.1
General Maintenance
1. Wash outside of filter with a mild detergent and
water. Rinse off with a hose. Do not use solvents
to clean the filter, solvents will damage the plastic
components of the filter.
2. Check pressure during operation at least once a
week.
3. Remove any debris from the skimmer basket and
hair/lint pot on pump.
4. Check pump and filter for any leaks. If any leaks
develop, turn off the pump and call a qualified pool
service technician.
5. Product safety signs or labels should be
periodically inspected and cleaned by the product
user as necessary to maintain good legibility for
safe viewing distance.
6. Product safety signs or labels should be replaced
by the product user when a person with normal
vision, including corrected vision, is no longer able
to read the safety signs or label message panel text
at a safe viewing distance from the hazard. In cases
where the product has an extensive expected life or
is exposed to extreme conditions, the product user
should contact either the product manufacturer
or some other source to determine means for
obtaining replacement signs or labels.
7. Installation of new replacement safety signs or
labels should be in accordance with the sign or
label manufacturer's recommended procedure.
6.2
Pressure Gauge
1. During operation of the filtration system, check the
pressure gauge/air release assembly for air or water
leaks at least once a week.
2. Keep the pressure gauge in good working order.
If you suspect a problem with the gauge, Zodiac
recommends you call a service technician to do any
work on the filter/pump system.
CAUTION
Maintain your pressure gauge in good working order. The
pressure gauge is the primary indicator of how the filter
is operating.
6.3
Cleaning the Filter Cartridge
1. Follow the procedures outlined in steps 1 through
8 of Section 5.1 to expose the cartridge elements
inside the filter.
2. Remove cartridge elements and place them upright
in an area suitable for washing.
3. Use a garden hose and nozzle to wash each pleat
of each element.
NOTE: Algae, suntan oil, calcium and body oils can form
coatings on filter element which may not be removed
by normal hosing. To remove such materials, soak the
element in de-greaser and then a de-scaler. Your local
pool dealer will be able to recommend suitable products.
4. Inspect each cartridge for holes, tears or
excessively worn pleats. Replace if necessary.
5. To reassemble the filter with the new or clean
cartridges follow the procedure outlined in steps 10
through 16 of Section 5.
Section 7. Winterizing
1. Turn off the pump and circuit breakers.
2. Open air release valve on top of the filter.
3. Remove the drain plug at the base of the filter to
ensure that the tank is empty. Store the drain plug
and seal in a safe place. Do not reinstall until next
season at start-up.
4. Drain system piping of all water.
5. Cover the system with a tarpaulin or plastic sheet
to protect it from the weather.
ENGLISH
Page 11

Publicité

loading

Ce manuel est également adapté pour:

Cv versaplumb