Whirlpool WDF560SAFM Manuel Utilisateur page 9

OPTION SELECTIONS
Delay displays how many hours before the cycle will begin.
To delay the start:
1. Select a wash cycle and options.
2. Press the Delay button. Each time you press DELAY, it
will display the next available delay time.
3. Press START to begin the delay countdown.
NOTE: If the door is opened, such as to add a dish, the Start button must be pressed to resume the delay countdown.
Sanitizes dishes and glassware in accordance with NSF
International NSF/ANSI Standard 184 for Residential
Dishwashers. Certified residential dishwashers are not
intended for licensed food establishments. Only sanitizing
cycles have been designed to meet the requirements of
the NSF/ANSI 184 performance standard for soil removal
and sanitization efficacy. There is no intention, either
directly or indirectly, that all cycles on a NSF/ANSI 184
certified dishwasher meet the NSF/ANSI 184 performance
standard for soil removal and sanitization efficacy.
Sani Rinse indicator is lit at the end of the cycle if the Sani
Rinse option was successfully completed. If indicator does
not light, it is probably due to the cycle being interrupted.
Raises water temperature to improve cleaning for loads
containing tough, baked-on food.
Turns the heating element on at the end of the wash
portion of the cycle. Its shorter heating time uses
significantly less energy compared to using Heat Dry.
Dries dishes with heat. This option, with the use of rinse
aid, will provide the best drying results. Plastic items are
less likely to deform when loaded in the top rack. Use Heat
Dry for optimum drying performance or turn the Heat Dry
option off for air dry.
Control Use the Control Lock option to avoid unintended use of dishwasher between cycles, or cycle and option changes during
Lock a cycle.
To turn on Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light will stay on for a short time, indicating
that it is activated. When the Lock indicator is lit, all buttons are disabled. If you press any button while your dishwasher is
locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked.
To turn off Control Lock, press and hold SANI RINSE for 3 seconds. Control Lock light turns off.
OPTIONS CAN BE WHAT IT DOES
SELECTED
WITH
Available Delays start of a
with any cycle up to
.
cycle 24 hours
Sensor Raises the main
Heavy wash temperature
Normal to 135°F (57°C)
and the final rinse
temperature to
156°F (69°C).
Sensor Raises the main
Heavy wash temperature
Normal to 135°F (57°C).
Available
with any
cycle
Sensor Uses a heating
Heavy element to speed
Normal drying times.
1-Hour Heat Dry option
Wash defaults to ON
when any cycle is
selected except
for 1-Hour Wash
and Light.
ADDED TIME ADDED
TO CYCLE WATER
GALLONS
(LITERS)
0:05 to 1:06 0 to 3.9
(0 to 14.6)
0:05 to 0:13 0 to 3.9
(0 to 14.6)
0:11 0
0:08 to 0:46 0
9