Braun CareStyle Compact Pro Mode D'emploi page 6

During steam
emission the system
produces a pumping
noise associated
with vibrations
Water droplets come
out of the soleplate
During ironing
white particles
and impurities are
coming out of the
soleplate
Water fl ushes out
of the soleplate
The fi rst time the
appliance is turned
on, you notice
smoke/smell
All LEDs are fl ashing
Français
Avant utilisation
Lisez attentivement toutes les instructions
avant d'utiliser l'appareil.
Attention: A cause de la puissance
élevée de cet appareil, veuillez vous
assurer que votre réseau électrique
12
If the water tank is full – this is normal
working condition
The water tank is empty
Steam condenses into water in the
hose when you use steam for the fi rst
time or have not used it for a long time
The water tank is empty
Your tap water is very hard
Impurities of chemicals present in the
water have deposited in the steam
vents and/or soleplate
The cleaning process has been
activated accidentally.
Some parts have been treated with
sealer / lubricant which evaporates
the fi rst time the iron heats up
System error
No action required
Switch off the system, unplug and fi ll
the water tank. Press the steam button
until the steam comes out.
This is normal. Hold the iron away
from the garment and press the steam
button. Wait until steam instead of
water comes out of the soleplate
Unplug and fill the water tank.
If your tap water is hard we recommend
you use either distilled water or
demineralized water
Perform the cleaning process regularly
even if not required by the system (see
dedicated chapter)
Switch off the appliance and unplug.
Put the iron on the cleaning vessel,
switch on and perform the cleaning
process completely (see dedicated
chapter)
This is normal and will stop after the
iron has been used a few times. If
the smoke/smell is still present after
turning off and cooling down, contact
an authorized Braun Customer Service
Unplug the system, plug in again. If
the problem is still present unplug
immediately and contact an authorized
Braun Customer Service
est adapté. Veuillez contacter votre
fournisseur d'électricité pour s'assurer
que l'impédance n'est pas supérieure
à 0,404 ohms.
Description
1 Bouton de mode
2 Témoin du mode Éco