Publicité
Les langues disponibles
Les langues disponibles
COMPUTER MANUAL
DISPLAYS
[TIME] Display: Shows actually time of exercising in minutes
and seconds.
[SPEED] Display: Shows actually speed in km/h during exer-
cise mode. Shows programs P01-P06 in stop mode.
[DISTANCE] Display: Shows actually distance in Km.
[CAL./PULSE] Display: Shows the approx. kilocalories con-
sumed in kcal or the pulse if a Bluetooth heart rate belt was
worn to measure the pulse.
KEYS:
[P]
Key:
exercising speed programs P01-P6
[Start] Key: Press this key to start exercise pro-
gram. The runing surface starts delayed by 3
seconds.
[Stop/Pause] Key: Press this key during ex-
ercise to interrupt the program (motor stops
running). You can press [Start] key to con-
tinue this exercise program or press [Stop/
Pause] key again to finish this program.
Prevalues can set to zero by pressing the [Stop/
Pause] key.
[+] Key: Press this key to increase settings or
motor speed.
[-] Key: Press this key to decrease settings or
motor speed.
[M] Key: Press this key to select the time dis-
tance or calories in the manual program.
press
this
key
to
START UP
The walkingpad can only controlled with the supplied remote
control. The remote control requires a button cell type CR2032.
Insert the battery into the remote control (5), respecting the po-
larity, or pull out the plastic battery separator. The range is ap-
prox.1.5m. If the remote control does not respond, first change
the battery.
PROGRAMS
Manual Program
1. Connect the power cable (25) to the treadmill and to a properly
installed socket (230V~50Hz) and turn on the power switch (22)
select
at the bottom front of the basic device. The computer will show
you the manual program and is ready to start.
2. Stand on the sidebars.
3. Press [ ] key to start with exercising. After a 3 sec. count down,
the motor begin to run slowly and you can step on the running belt
and follow the speed.
4. Adjust the speed with [+] and [-] keys into desired speed.
Time- Program:
On the normal manual mode, press [M] key, to enter time pro-
gram. The time display will flash and the initial value is 30:00.
Press [+] or [-] keys to set value. The range is: 5:00-99:00. Press
[ ] key to start the program. If set a value the display counts up till
zero and then stops running motor.
Distance- Program:
On the normal manual mode, press [M] key, to enter distance
program. The distance display will flash and the initial value is
1,00KM. Press [+] or [-] keys to set value. The range is: 0,5-65:0
KM. Press [ ] key to start the program. If set a value the display
counts up till zero and then stops running motor.
Calories- Program:
On the normal manual mode, press [M] key, to enter calories pro-
gram. The calories display will flash and the initial value is 50kcal.
Press [+] or [-] key to set value. The range is: 10-995kcal. Press
[ ] key to start the program. If set a value the display counts up till
zero and then stops running motor.
RANGE OF ALL FUNCTIONS
TIME (Min:Sec)
KM/H
KM
CALORIES (Kcal) 0
14
Initial
Setting
Initial
Value
Range
0:00
30:00
5:00-99:00
0.0
N/A
N/A
0.00
1.00
0.5-65.0
50
10-995
GB
Display
Range
0:00-99:59
0.8-5.0
0.00-99.99
0-999
Publicité
