Publicité
Les langues disponibles
Les langues disponibles
Disconnect the power cord before cleaning or leave the door open to inactivate the oven during cleaning.
EXTERIOR
The outside surface is precoated steel and plastic.
Clean the outside with mild soap and water; rinse and
dry with a soft cloth. Do not use any type of household
or abrasive cleaner.
DOOR
Be careful with the edge of the oven door as it is glass
and could chip or break. Wipe the window on both
sides with a damp cloth to remove any spills or spat-
ters. Metal parts will be easier to maintain if wiped
frequently with a damp cloth. Avoid the use of spray
and other harsh cleaners as they may stain, streak or
dull the door surface.
STAINLESS STEEL SURFACE
The exterior should be wiped often with a damp cloth
and polished with a soft dry cloth to maintain its beauty.
There are also a variety of products designed especial-
ly for cleaning and shining the stainless exterior of the
oven. We recommend that the cleaner be applied to a
soft cloth and then carefully used on the stainless exte-
rior rather than sprayed directly onto it. Follow package
directions carefully.
INTERIOR
Cleaning is easy because little heat is generated to the
interior surfaces; therefore, there is no baking and set-
ting of spills or spattering. To clean the interior surfaces,
wipe with a soft cloth and warm water. DO NOT USE
ABRASIVE OR HARSH CLEANERS OR SCOUR-
ING PADS. For heavier soil, use baking soda or a mild
soap; rinse thoroughly with hot water. NEVER SPRAY
OVEN CLEANERS DIRECTLY ONTO ANY PART OF
THE OVEN.
TOUCH CONTROL PANEL
Wipe the panel with a cloth dampened slightly with wa-
ter only. Dry with a soft cloth. Do not scrub or use any
sort of chemical cleaners. Close door and touch STOP/
CLEAR.
ODOR REMOVAL
Occasionally, a cooking odor may remain in the oven.
To remove, combine 1 cup water, grated peel and juice
of 1 lemon and several whole cloves in a 2-cup glass
measuring cup. Boil for several minutes using 100%
power. Allow to set in oven until cool. Wipe interior with
a soft cloth.
All manuals and user guides at all-guides.com
Models MWOR330A2ABL/WH/SS, MWOR330A3ABL/WH/SS
Cleaning And Care
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non-abrasive
scouring sponge. They are also dishwasher-proof. Use
upper rack of dishwasher. The turntable motor shaft is
not sealed, so excess water or spills should be wiped
up immediately.
WAVEGUIDE COVER
The waveguide cover is located on the right side wall of
the oven cavity. It is made from mica so requires spe-
cial care. Keep the waveguide cover clean to assure
good oven performance. Carefully wipe with a damp
cloth any food spatters from the surface of the cover
immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. Do
not remove the waveguide cover.
GREASE FILTERS
Filters should be cleaned at least once a month. Never
operate the fan or oven without the filters in place.
1. Pull down slightly on the tab toward the front of the
oven and remove the filter. Repeat for the other filter.
2. Soak the filters in a sink or dish pan filled with hot
water and detergent. DO NOT use ammonia or
other alkali; they will react with the filter material
and darken it.
3. Agitate and scrub with a brush to remove embed-
ded dirt.
4. Rinse thoroughly and shake dry.
5. Replace by fitting the filter back into the opening.
Grease filter
Use & Care Manual
ENGLISH
Tab
21
Publicité
