Programming Inputs; Calibration Procedure Notes - Balluff BTL7-A/C/E5-M-SF-F Notice D'utilisation

BTL7-A/C/E5 _ _ -M _ _ _ _ -SF-F _ _
Magnetostrictive Linear Position Sensor – Rod Style
6
Calibration procedure
Output BTL
gradient
Rising BTL7-A...
BTL7-C...
BTL7-E...
Falling BTL7-A...
BTL7-C...
BTL7-E...
Tab. 6-1: Value table for teach-in and inverting
6.1

Programming inputs

Programming inputs La and Lb must be used in order to
make settings. A programming input at 10 to 30 V
corresponds to activation (high active).
The Balluff calibration box BTL7-A-CB02-... can be used
for this (see Accessories on page 20).
Automatic deactivation!
If no signals are transmitted via the
programming inputs for approx. 10 min,
programming mode is automatically ended.
6.2

Calibration procedure notes

Prerequisites
– Programming inputs are connected.
– The BTL connected to the system controller.
– Voltage or current values from the BTL can be read
(using a multimeter, the system control or the
calibration box).
Fig. 6-1: Connecting the calibration box BTL7-A-CB02-S...
12 english
Unit Min. Null
value value
V –0.5 0
mA 0 0
mA 3.6 4.0
V +10.5 +10.0
mA 20.4 20.0
mA 20.4 20.0
BTL
8-pin luster strip
Indication for Indication
adjustment for teach-in
2.0 4.0
6.0 12.0
6.0 12.0
2.0 4.0
6.0 12.0
6.0 12.0
Values for null and end point
– Any desired position of the float can be used as the null
or end point. However, the null and end points may not
be reversed.
– The absolute null and end points must lie within the
minimum or maximum range of what can be output
(see value table).
The last set values are always saved, regardless
of whether the setting was ended using the
programming inputs or automatically after
10 min. have expired.
Value table for teach-in and inverting
The following examples refer to BTLs with
0...10 V or 4...20 mA output.
Calibration box
YE YE
8-pin
GY GY
PK PK
RD RD
GN GN
BU BU
BN BN
WH WH
End Max. Error
value value value
+10.0 +10.5 +10.5
20.0 20.4 20.4
20.0 20.4 3.6
0 –0.5 –0.5
0 0 20.4
4.0 3.6 3.6
Supply
6-pin
Adapter cable with
connector (luster terminal)