Getting Started; Batteries; Paper Load; Self Test - Wohler TD 100 Mode D'emploi

5

Getting started

5.1

Batteries

7
8
9
Fig. 5: Bottom of the printer
5.2

Paper load

Fig. 6: Paper compartment open
6

Self test

•
6
•
•
•
•
•
•
Open the battery compartment at the bottom
of the printer by pulling the lever (8) and re-
moving the battery cover (9) at the same time.
NOTE!
Pull the lever strongly. The safe closure guaran-
ties that the battery compartment will not open
accidentally.
Insert 4 AA batteries. Observe the polarity
indicated on the bottom of the battery com-
partment.
NOTE!
Remove the batteries, if you intend not to use the
printer for a certain time.
NOTE!
When the battery voltage gets too low to support
the printing, the red LED light blinks. In this case
change the four batteries.
Open the paper compartment by pulling down
the lever at the right side of the printer (Fig. 1,
part 5).
Put the cover of the paper compartment in a
vertical position (Fig. 1, part 4).
Insert the paper roll as indicated in the bottom
of the paper compartment.
Pull the end of the paper roll out of the paper
compartment and close the cover.
NOTE!
The cover must audibly engage.
Hold down the FEED PAPER button (▲) and
then press the POWER button.
The printer will run a self test and print out all
fonts, the audio sleep status, the serial number
Contents
EN
19