Locinox SlimStone-X Manuel page 14

11. REPLACE SWITCHSTONE-STD
• Physically remove the SwitchStone-STD from the
network
• Install and connect the new SwitchStone-STD
• Confirm that the SwitchStone-STD is in the reset
EN
status (= all LEDs are flashing counterclockwise). In
case it's not in reset status, see chapter 8. 1 to reset
the SwitchStone-STD
• Access programming mode (see 7. 1 )
• Select [7] and confirm with [#]
• The SlimStone-X will add the SwitchStone-STD to
the network
In case the SwitchStone-STD was not found,
an error message will be shown by left-right
flashing of the keypad LEDs
15. TROUBLESHOOTING
• When I try to add a new PIN code or change the
timings of a relay, I always get an error (left-right
flashing)
• The SlimStone-X lighting is off after pushing
a button
• The SlimStone-X does not react after entering
the code
• The lights flash after entering the PIN code and
confirmation by pressing [#]
16. FREQUENTLY ASKED QUESTIONS
• Is the keypad heated?
• How weatherproof is the SlimStone-X?
A discarded device can either be returned to your dealer or be sent back to Locinox. This product's
recycling fee is € 0,2.
The WEE marking on the product indicates that it may not be thrown away together with normal
household waste and must be handed over to a designated collection point for the recycling of
electrical and electronic rejects.
As manufacturer of this product, we guarantee that we have taken all the necessary steps in order
to comply with the current safety requirements for this product.
14
PROBLEM
QUESTION
12. MAINTENANCE
• Clean the housing and display using a soft cloth,
moistened with a neutral cleaning agent
• Never use fuel or chemicals on the device since
they might harm the housing
13. GENERAL INFORMATION
• Please observe the local regulations on the deposit
of packaging material and of appliances no longer
in use Our packaging material is eco-friendly. It
can be divided into 2 materials: cardboard (box)
and expandable polyester (buffer)
• Your device is made of recyclable materials
14. WARRANTY
A 2 year warranty covers all electronics
SOLUTION
• Verify the cabling between the SlimStone-X and
SwitchStone-STD. When the SlimStone-X cannot
communicate with the SwitchStone-STD, all lights
flash left to right.
• Verify the power supply connection
• Entering a code must always be confirmed
with [#]
• The entered code does not match any of the
registered codes. See 8
ANSWER
• Yes, SlimStone-X has a regulated heating system
which keeps the keys frost-free
• SlimStone-X is designed to comply with the IP68
standard
SlimStone-X