Olimpia splendid Maestro Smart 2216 Directives D'installation, D'utilisation Et D'entretien page 29

DISPLAY
D1 Fan speed or automatic operating mode
indicator (AUTO)
D2 Heating mode
D3 Cooling mode
D4 Dehumidification only mode
D6 Sleep mode operation
D7 Automatic operation
D8 First operating program
D9
Second operating program
D10 Temperature indicator or time indicator
(Hours/minutes)
D11 Desired temperature/clock/programming
D12 Fan speed
D13 Transmission of the command in progress
D14 Program switching off time setting
D15 Clock/program setting
D16 Program switching on time setting
D17 Low battery notification
D18 Minutes timer
3.3.3 - Unit start up (fig.34)
To operate the unit using the remote control it will be necessary to turn on the main switch on the electrical
power supply line or by inserting the unit's electrical plug into the appropriate wall outlet.
• The unit is equipped with a power switch (10) located below the lower safety guard (9).
• To run this power button must be in "I" position.
• At this point the unit can be operated by the remote control. In order to transmit commands to the unit,
point the front of the remote control toward the unit's control panel.
• The unit emits a beep when it receives a command.
• The remote requires direct line of sight with the unit's receiver with a maximum distance between them
being 26 feet (8 m).
D4
D3 D13
D2
D11
D6
D12
D7 D14
D8 D15
D9
D16
D10
D17
D18
D1
D
US-ENG- 17
MAESTRO SMART