Publicité
Les langues disponibles
Les langues disponibles
Reversing the Door (
fig. 5 & 6)
This freezer is equipped with a reversible door for left/right opening. If you prefer
to change the direction of door opening, follow the steps below:
Note: The freezer comes with the door hinged to the right.
Installing the Door
fig. 5
1. Fix the freezer door in place with strong adhesive tape.
2. Dismantle the hinge box cover on the top of the freezer door with a Phillips
screwdriver and remove the 2 screws from the hinge. Take out the hinge by
pulling up vertically. Put these aside.
3. Remove the adhesive tape on the freezer door, lift and take the door
down.Carefully put it aside.
4. Remove the door pin from the bracket of the lower hinge by turning it counter
clockwise. Move the pin to the opposite hole and tighten. (see fig. 6)
5. Remove the 4 screws from the lower hinge with a Phillips screwdriver. Remove
the washer and shim from the right side and install them to the left side.
6. Align the holes in the lower hinge bracket to the corresponding holes on the
opposite side of the cabinet. Insert and tighten screws.
7. Align the bottom hole on the lower left side of the door with the pin of the lower
hinge and slide into place.
8. Align the pin of the top hinge with the top hole on the left side of the door and
push in place. Replace the screws in the upper hinge bracket but do not tighten
all the way.
9. Align the door from top to bottom and tighten the 2 screws on the top hinge.
10. Snap on the hinge box cover.
11. On some models you need to screw the hinge box cover using a phillips screw
driver.
Shim
Door Pin
fig. 6
(see
fig. 5)
English
washer
10
Publicité
