Publicité
Les langues disponibles
Les langues disponibles
1.
Open the door and remove the decorative nail (2) on the left side (Fig.A)
2.
Remove all screws from the upper and lower hinge, and then remove the
door (Fig.A).
3.
Press the door lamp tablet (6) Remove and install it on the upper door
frame, and then rotate the door 180 degrees (Fig.D, E).
4.
Fix the screw in the upper left corner of the case, and be careful not to
tighten it (Fig.B).
5.
Put the door hinge into the screw in the upper left corner, align with the
slot, and tighten the screw to ensure that the door hinge is tight (Fig.C).
6.
Install the decorative nail (2) in the upper right corner of the box (Fig.C).
2.7 Installing the appliance
Place you wine cabinet on a floor that is strong enough to support it when it
is fully loaded. The kitchen unit must be aligned horizontally and vertically.
You will need to install a furniture door frame to the front of the wine cabinet
once wine cabinet has been installed.
The furniture door frame can be custom made (by the kitchen reseller) to line
up with your other furniture doors in the kitchen. The door must be finished on
both sides in order to prevent warping.
Steps
1. If you want to adjust the height over 820mm, please install the product
using the foot sliders provided. These are provided to help prevent the
feet catching on the floor when sliding the appliance into the aperture.
BACK
2. To level your wine cabinet, adjust the front and back by leveling adjustable
legs at the bottom of the cabinet (to 4mm less than the recess or handlebar
height). Ensure it's perfectly leveled, as this will minimize any vibrations and
noises.
3. Slide in the appliance until the front surface of the appliance door is behind
16
FRONT
Publicité
