Panasonic CZ-RTC6 Instructions D'installation page 8

3
Mount the top case.
● Align the claws of the top
case and then align the
claws of the bottom case.
● If the wiring is difficult to
move, loosen the screw in
the lower case, work on the
wiring, then screw in the
screw after finishing the work.
Avoid the
wire being
caught.
Claw (2 places)
2
Connect the remote control wiring.
• Be sure not to allow unnecessary wires to
remain in the remote controller case when
wiring. Be careful not to allow wires to be in
contact with parts on the PCB. For connection
method, refer to "Connection to the remote
controller terminal board" in "Attention".
8
(EN)
All manuals and user guides at all-guides.com
Embedded type
1
Mount the bottom case to
the wall.
● Pass the wire through the
wiring hole in the bottom case.
Hole for screw
Claw (2 places)
Screw
(Supplied)
*It is also possible to mount in the order
Pass the wire under the rib.
Remove the coating. Approx. 9 mm
● Make sure the wiring connection
is in the correct direction.
• Insert the clamper from the
position indicated by the arrow,
as shown in the diagram at right.
• Put the locking part of the
clamper in the channel as
indicated by the arrow.
• If you lock at the top, it may not
be possible to close the bottom
case.
Remote controller
terminal board
Clamper
(supplied)
2 3
→ 1 → .